AEM 22 Channel CAN Sensor Module

AEM 22 Channel CAN Sensor Module

The 22 Channel CAN Sensor Module (PN 30-2212) converts analog, digital and frequency inputs into an AEMnet CAN bus signal that can be transmitted to the CD-5 Carbon and CD-7 Digital Dashes and displayed alongside EV CAN bus channels and recorded in one log file. The 22-Channel CAN Sensor Module is compatible with the CD Dashes only; it will run in parallel with 3rd party CAN devices on the CD dashes but it is currently not compatible with any other EV VCUs or data loggers.

Convert analog, digital and frequency-based inputs to AEMnet CAN bus for display on CD-5 Carbon and CD-7 Dashes!
Ideal for users who want to display and log channels not present on the EV system CAN bus
Daisy chain two Modules together for up to 40 additional channels
IP65-rated enclosure is ‘dust tight’ and water resistant
Wiring harness included with 36-inch flying leads and pre-wired CAN cable
Four dedicated 0-5V Analog inputs
Four Temperature (thermistor) inputs
Four user-configurable Analog inputs, (jumper selectable; 0-5v, thermistor, or RTD)
One dedicated Fliud Level input (0 to 250 ohm range)
Six configurable Digital or Frequency inputs, active low, protected to ~18v, frequency, duty cycle or simple switch
One Tach input, trigger when low, 12v internal Pull Up
Two VR Pair Frequency inputs (motor, wheel or drive shaft speeds)
Jumper selectable CAN bus speeds, 250k,500k,1M
Jumper selectable terminating resistor
Jumper selectable header length, 11bit or 29 bit
Dimensions: 4.7” L x 4.3” W x 1.4” H (not including connector)
Weight: 6.4oz / 180g