

Tesla Model S Custom drive shafts
Custom drive shafts to fit into your car
Tesla Model S Custom drive shafts
Custom drive shafts to fit into your car
Send us your OEM drive shafts and we will make the modification for the Tesla drive unit
Reference: TBMSREPPCB-V1
1 x Plug&Play replacement board of the OEM Tesla Model S/X slave board (only for battery modules with silicone balancing wires), to be used with Orion BMS product line.
Reference: Gigavac BD9513
Brand: GIGAVAC
Gigavac BD9513 Manual Battery Switch GIGAVAC manual battery disconnect switches provide a level of sealed switching technology to meet any application requirement.
Reference: waterpumpleaf
Commonly referred to as water pump 1, this pump is located on the driver’s side of the engine bay next to the motor itself (refer to images for location). The fault codes associated with this pump are P31E8 and P31E9
Reference: TS2LDV
Tesla Large Drive Unit 4 Pin Encoder Connector Model S & X This 4 pin plug fits the Tesla large drive unit encoder outlet on the base and performance drive units. This is a complete kit including pins to crimp on your cur cables to allow you to build a professional loom.
Reference: TESmp1-5
Brand: TE CONNECTIVITY
Superseal connector male 1 to 5 pin TE connectivity superseal connector wire to wire
Reference: Gigavac HBD21AA
Brand: GIGAVAC
GIGAVAC manual battery disconnect switches provide a level of sealed switching technology to meet any application requirement.
Reference: LDUAlCasing
This solution is made for all Tesla Large drive unit split setup
Reference: TSLSPRI013-5
SPRI013-5 is a used precharge for Tesla Model S
Reference: Yazaki7282-8854-30
Yazaki 7282-8854-30 connector This connectors are used in Renault electric vehicles
Reference: J1772
The EVSE Interface allows you to charge your EV from standard AC (L1 and L2) charging stations using the SAE J1772 standard. It works with both Type 1 connectors (USA, Japan, etc) and Type 2 (Europe, Australia, etc).
Reference: HEPA
Made of high quality materials which prove to be very reliable. This pedal is easy to use and can give even the oldest of vehicles a new car feel with this drive-by-wire assembly.
Reference: 3Dphaseprotection
Hyper 9 Phases 3D printed inverter protection
Reference: 776164-1
35 pin Molex for SME and Curtis controllerSold with 35 pin
Reference: 770680-1
23 pin Molex for Tesla Large Drive UnitSold with 23 pin
Tesla Model S Custom drive shafts
Custom drive shafts to fit into your car
Chat with us on WhatsApp